How to program chamberlain garage door opener?

In this article I’m going to explain you how to program garage door opener remote and program rear view mirror of the car with your garage door opener. But don’t worry if you have a different car like BMW, Ford, chevy, Lexus and mercedes Benz because the same process works on most of the cars out today.

Program garage door opener remote

We’re going to show you how to program your remote control. To reprogram a remote to your garage door operator first thing you want to do is find this learn button.

Sometimes it’s under a light cover and you have to open that light cover but it’s always going to be where all your wires are going into the end of the garage door opener.

So once you find that go ahead and flip that open make sure you have your remote with you up on the ladder. While you’re doing this you have to press LEARN button one time you will see that light come on. It might be Red purple or yellow go ahead and hit that one time.

How to program garage door opener remote

Now technically the remote is not programmed it’s this that is programmed to understand the remote’s signal. This remote will emit three different distinct signals and you are going to train the opener to recognize it. So you can use any brand of remote.

They all seem to usually work. They don’t have to be an exact model. Don’t hold it down you just want to hit it one time then go ahead and you’ve got about 30 seconds or so to go ahead and hit your other button on the remote that you want a program. When you hit first time you will hear the Machine click sound. Second time you hit it you’ll hear the door run. If you accidentally make a mistake by hitting a wrong button while you have to process again from starting.

How to program rear view mirror of car with garage door opener?

 To start the process jump inside the vehicle and look up towards the rear of your mirror you’re looking for three buttons that have home icons written on them you can use the same method to program all three buttons.

 But we’re just going to program the first button now. First we need to reset all the codes and even if your vehicle is brand new I think it’s important to do this just to wipe it completely clean.

To reset the unit, you need to hold 1st and 3rd buttons with your hands for about 15 to 20 seconds until you see the red indicator light flash repeatedly.

To program your vehicle hold your garage door open or about three inches away from it and you want to push and hold your garage door opener and the first button on the rear of your mirror at the same time and hold them until you see the red light flash repeatedly.

It doesn’t work on every garage door opener but if it works on yours you’ll be able to push and hold that first button for about a second and then your garage door should open.

If it doesn’t work we have to go through an additional step together it actually didn’t work on my garage door so what you’ll have to do is go into the garage and get out a ladder climb up to your garage door unit and pry off one of the back covers you’ll see a button that’s marked LEARN on the back.

It was a red button and once you push the red button you’ll have 30 seconds to run back to your vehicle start it up and then push and hold that first home button again once the indicator light flashes.

 That means that your car has been programmed with your garage door opener code and it should work. Just note that this is not like a cap when you want to activate their garage door you’re actually going to have to push and hold the home button for about one second to activate your garage door.

I hope this article helped you to learn program the remote control of garage door opener and car rear mirror.

Programming chamberlain garage door opener

You can program chamberlain garage door opener very easily. Check the video below.

Also check programming genie garage door opener.

Scroll to Top